OPERATING INSTRUCTIONS (continued) Volume Adjustment
The volume can be adjusted by pressing the VOL+ and VOL- buttons of the remote control (or the L and M volume buttons of the monitor unit) while the on-screen display system is not being displayed.
Volume setting value
�
�
VOLUME 15
VOLUME buttons INPUT SELECT button
Adjustment status guide display
� When a button is pressed, the volume adjustment status guide will be displayed.
VOL
MUTE
VOL
VOLUME UP/DOWN buttons
� The volume will increase when the VOL+ (or L) button is pressed while the guide is being displayed. � The volume will decrease when the VOL- (or M) button is pressed while the guide is being displayed.
MUTE button
AUTO PinP SIZE RECALL
� The volume can also be adjusted with the on-screen display system. 19
RGB/VIDEO buttons
RGB 1
RGB 2
VIDEO 1
VIDEO 2
MENU
RETURN
Audio Mute
The audio volume can be temporarily lowered to the mute volume level by pressing the MUTE button of the remote control.
Volume setting value
ENTER
ID
ID SET
VOLUME 15
Input Switching
・ Input can be switched by pressing the RGB1, RGB2, VIDEO 1 or VIDEO 2 buttons of the remote control. ・ Input can be switched in the sequence of RGB1 � RGB2 � VIDEO 1 � VIDEO 2 by pressing the INPUT SELECT button of the monitor.
Adjustment status guide display (The display color will change to pink.)
� When a button is pressed, the word MUTE (in pink) and the volume adjustment status guide will be displayed.
� The volume setting can be lowered by pressing the VOL- button while the audio is muted. � The muting can be cancelled by pressing the VOL+ button while the audio is muted.
When INPUT SELECT is pressed:
RGB1 RGB2 VIDEO1 VIDEO2 (D-sub input) (D-sub input) (composite or S input) (component input)
� When audio is muted with the on-screen display system, the volume setting can be adjusted.
19
When the MUTE button of the remote control is pressed again, muting will be canceled, the volume display (blue) will appear and sound will be output.
� If the video unit is not installed, you cannot switch to VIDEO1 and VIDEO2. � When the same signal is input to RGB1 and RGB2, the phases may be slightly misaligned. This is not a malfunction. In such case, please change one refresh rate (Vertical frequency 31 ) of the apparatus to be used.