Step 3: Presetting radio stations (continued)
To change the AM tuning interval (except for European model)
The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the TUNING + button, turn the power back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure. Tips
� When a new station is memorized, the station formerly memorized at that preset number is erased. � The preset stations are retained for a week even if you disconnect the AC power cord or if a power failure occurs. � If noise is heard while listening to an FM station, remove the FM antenna from the rear panel and place the antenna outside the cabinet.
Saving the power in standby mode
You can lower the power consumption to a minimum (Power Saving Mode) and save energy in the standby mode.
DISPLAY
, Press DISPLAY when the power is off.
The unit switches to the Power Saving Mode and the clock display disappears. The system turns on/off by pressing ?/1.
To cancel the Power Saving Mode
Press DISPLAY. The clock display appears. Notes
� When the Daily Timer is set, you cannot switch to the Power Saving Mode. � When the Daily Timer is set in the Power Saving Mode, the Power Saving Mode does not function until the timer is canceled.
