Assembly and Installation 1
Remove base
Using the provided Allen wrench, remove the three base screws and then the base from the speaker. Save these screws and the base if there is any chance you will want to replace the bases for ordinary floor installations in the future.
4
Temporary mounting
NOTE When the mounting fixture is combined with the speaker system S-VSL3, the total weight is about 10 kg. The installation technician should decide on the optimum mounting method based on an assessment of the wall�s materials and structure. � Confirm the height from the floor. Enough space must be left between the floor surface and the speaker body to allow the introduction of a screwdriver in order to install and tighten the terminal cover.
70
76.6 962.6
Hole for temporary mounting (� 5.5)
Using the furnished 3 mm Allen wrench, remove the four screws from the top of the speaker. Place the upper plate on the speaker top and use the 3 mm Allen wrench to tighten the removed mounting screws.
Consult the dimensional diagram on P. 9 for external dimensions following speaker installation.
85
Floor
5
Since the hex holes in the mounting screws are rather shallow, be sure to hold the Allen wrench securely to prevent slipping, and tighten the screws securely to prevent slipping.
Mark the position of the mounting screws
Use a level or plumb bob to confirm the perpendicular, and mark the position of the mounting screws on the wall. The mounting screws should have a diameter of 4-5 mm (5 mm is recommended) in 6-8 locations. The safety strap location and mounting screw diameters should be 1 screw of 5-6 mm in the upper square hole (6 mm is recommended); bushing location and screw diameters are 2 screws of 5-6 mm (6 mm recommended) within the 9x15 rectangular hole.
3
Fasten the safety strap to the speaker
Temporarily remove the mounting fixture on the rear of the speaker, place around the safety strap and once again fasten the mounting fixture to the speaker.
Safety strap
