Alarm Time Setting
The 12-hour system is used for the clock.
Initial Alarm Time
Press and hold [ALM] (Alarm)
�AM 12:00� is displayed when the alarm is not adjusted.
APM PRG
CQ-2130U
CLK ALM
PWR
BAND
LOUD
VOL
PUSH
MUTE
SEL
BASS/TREB BAL/FADER
TUNE SEEK
SCAN
1
2
3
4
5
6
ILL
[{] (Hours)
[}] (Minutes)
Alarm Time Setting
q Press and hold [ALM] (Alarm) and do not release to set alarm time. Display blinks and the alarm time setting mode is activated. (blink.)
Alarm Operation
� Alarm is switched to ON or OFF each time [ALM] is pressed. � When the alarm is switched to ON, the alarm will sound at the set alarm time. Turning off the Alarm Sound The alarm will turn off automatically after 90 seconds. Otherwise, press [ALM] once.
Hours
w Press [{] to set the hour. (Hours set.)
Alarm output Volume Selection
You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in sequence and the display will show as follows. a a OFF
Minutes
e Press [}] to set the minute. (Minutes set.) r Once the alarm time has been set, release [ALM]. Note: Press and hold [{] or [}] to change numbers rapidly.
Alarm Time Reset
When you want to reset the alarm time, repeat steps q to r.
Cautions: � Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving. � If the alarm is set, be sure to check the set alarm time by pressing [CLK]. � If volume is set at �0� level, the output volume will be muted. (Even when ALARM is acting.)
