|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
E N G L I S H 35
Installation Guide (continued)
Installation Procedures
First complete the electrical connections, and then check them for correctness. (page 56) Remove the mounting collar 1 and the trim plate 7 from the main unit temporarily, which are already mounted at shipment. 6 Power connector Mounting springs (§) The included mounting collar 1 is designed speci�cally for this unit. Do not use it to attach any other model.
Remove the Unit
Switch off the power of the unit.
E N G L I S H 36
1 Remove the removable face plate. (page 49)
Screwdriver
7 Trim plate
1 Insert mounting bend the mounting tabs out collar 1 into the dashboard, and
with a screwdriver. The tabs to be bent vary depending on the car. To securely install the unit, fully bend a number of the tabs so that there is no rattling. Example: Tab
2 Remove the trim plate 7 with a screwdriver. 3 1 Insert the lock cancel plates 8 along the
grooves on both sides of the main unit until �click� is heard. 2 Pull out the unit while pushing the plates further inside.
1 Insert. Insert the tab end in the outer groove.
2
5 Mounting bolt Mounting holes
Secure the rear of the unit. After �xing mounting bolt 5 and power connector 6, �x the rear of the unit to the car body by either method (a) or (b) shown below.
�Click�
8 Lock cancel plate
3 Insert trim plate 7.
2 Pull out. Engage the mounting springs (§) in the mounting holes of the mounting collar 1 �rmly. Mounting hole Mounting springs (§)
4 After installation,
negative - battery terminal.
reconnect the
4 Remove the unit pulling with both hands.
(a) Using the rear support strap 3
Fire wall of car 4 Tapping screw 3 mm·
(b) Using the rubber cushion (option)
Rear support bracket Rubber cushion (option) (provided on the car)
2 Hex. nut 3 Rear support strap 5 Mounting bolt 5 Mounting bolt 1 Mounting collar 1 Mounting collar
54
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
55
|
|
|
> |
|
