|
Kto jest w sklepie?
Sklep przegląda 6043 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Troubleshooting
If You Suspect Something Wrong
Check and take steps as described below. If the described suggestions do not solve the problem, it is recommended to take the unit to your nearest authorized Panasonic Servicenter. The product should be serviced only by qualified personnel. Please refer the checking and the repair to professionals. Panasonic shall not be liable for any accidents arising out of neglect of checking the unit or your own repair after your checking. Never take measures especially for those other than indicated by italic letters in �Check point� described below because those are too dangerous for users to handle themselves.
Warning
¡ Do not use the unit in an irregular condition, for example, without sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer. ¡ Never try to repair the unit by yourself because it is dangerous to do so.
Trouble
Check point
Trouble
Check point
Common
� Start the engine. (Or turn the ignition switch to the ACC position.) � Verify the wiring. (battery lead, power lead, ground lead, etc.) � Fuse blown (Contact the nearest Panasonic Servicenter.) � Ask a professional for fuse replacement. � Be sure to use the same rated fuse. � Disable the mute function. � Verify the wiring. � Wait until the dew disappears before turning on the unit.
Disc Player
No sound, or disc is automatically ejected Sound skip, poor sound quality Sound skip due to vibration Disc unejectable
� Load the disc correctly. � Clean the disc.
No power
� Clean the disc. � The maximum permissible tilt angle is 30°. � Secure the unit. � Press [u]. If the disc is still not ejected, contact the nearest Panasonic Servicenter.
No sound
Noise No sound from left, right, front, or rear speaker Left and right sounds are reversed
� Make sure that grounding is established
properly. � Adjust the balance and fader. � Verify the wiring.
Error Display Messages
(The disc is ejected automatically.) The disc is dirty, or is upside down. The disc has scratches. � Check the disc.
� Connect the speaker lead correctly.
Radio
Frequent noise
� Tune in to another station of high-intensity waves. � Make sure that the antenna mounted point is grounded properly. � The preset memory is cleared to return
No operation by some cause. � If normal operation is not restored, consult your dealer or the nearest Servicenter to ask for repairs. Cannot read the file � Check the file.
Preset data deleted
to the original factory setting when the power connector or battery is disconnected.
|
|
|
> |
|