PANASONIC CQVD7005U
Instrukcja Obsługi

Note: ¡While the private mode is active, only
FRONT L FRONT R

SOURCE LEVEL
Setting the AV1/AV2 input level
Make this setting if it is not possible to adjust the volume through the connected device (on the output side).

36

and can be

adjusted.

AV1 LEVEL TEST TONE
ON OFF
(Test tone output) : enables the test tone. : disables the test tone. default:
OFF

(Setting for AV1)

LOW HIGH

: sets the level low/sound volume increases. : sets the level high/sound volume decreases.

default:

HIGH

AV2 LEVEL
LOW HIGH

(Setting for AV2)

¡When the test tone is set to on, test signal (a continuous tone) is output from each speaker for approximately 2 seconds. Adjust the output balance so that the tone appears to
have the same volume from each speaker. Adjusting the output balance: Adjust the volume of all of the other speakers to the volume level of the speaker from which the test signal appears to be the quietest.

: sets the level low/sound volume increases. : sets the level high/sound volume decreases.

TIME ALIGNMENT
Adjusting the timing with which the audio from each speaker reaches the listener�s position (Center speaker delay time setCENTER ting)
] : down,

Note: ¡If the input level from AV1/AV2 is too high, the audio will not be output normally. ¡After setting the input level The volume can be adjusted by pressing [+] or [�] (VOL) on the remote control or turning rotary volume controller on the unit. default: HIGH

CROSS OVER
Cut off frequency

[ : up
Setting range: 0 ms to 5 ms (1 ms steps) 1 ms = 0.001 seconds default: 0 ms

LPF CUT OFF
] : down,

(Sub-woofer Low Pass Filter)

[ : up Setting range: 63 Hz to 200 Hz default: 125 Hz

SUR
] : down,

(Surround speaker delay time setting) [ : up

HPF CUT OFF
] : down,

(High Pass Filter)

Setting range: 0 ms to 15 ms (1 ms steps) 1 ms = 0.001 seconds default: 0 ms ¡Make this adjustment while listening to sound. ¡If the speaker setting is NONE for a speaker, that speaker cannot be selected. ¡When �PRO LOGIC� is displayed, 15 ms are automatically added to the delay time setting for the surround speakers.

[ : up Setting range: off, 63 Hz to 200 Hz default: off

Note: ¡This setting is not available if CS Auto is set to ON . ¡ HPF CUT OFF is enabled only on the front speakers (R/L) and rear speakers (L/R).

CQ-VD7005U

English
37