ONKYO CR305TX
Instrukcja Obsługi

Connecting speaker systems
Connecting left and right speakers
� The load impedance of each speaker must be at least 4 ohms. � Do not use unnecessarily long or extremely thin speaker cords. Otherwise, the DC resistance of the speaker cords may become too high, lowering the damping factor and causing the sound quality to deteriorate. � Do not connect the speaker cord to the L and R connectors at the same time and do not connect two or more speakers to the same speaker connectors.

NO
SPEAKERS R L

NO
SPEAKERS R L

Preparing the speaker cords for connection
1. Strip 10 mm from the end of each cord.
10mm (7/16�)

2. Twist the stripped end of the cord.

Note To prevent damage to circuits never short-circuit the positive (+) and negative (-) speaker wires.

NO

Connecting the speaker cords to the speaker connectors

SPEAKERS R L

1. Push the lever up.

2. Insert the stripped end of the cord.

�+
Right ch. Speaker

�+
Left ch. Speaker

3. Press down the lever. The wire of the stripped end of the cord should appear slightly.

8