Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
Sealed
Burners
Pilotless
Ignition
The four sealed burners of your Maytag range are secured to the cooktop and are not designed to be removed. Since the four burners are sealed into the cooktop, boilovers or spills won't seep underneath the eooktop. Thus, there are no hidden spills in the burner box area to clean, Your rm_ge features two special Power Burners located in the left rear and right front positions, These offer higher speed cooking that can be used to quickly bring water to a boil and for large-quaJ_tity cooking. (Power Burners are not found on the CI/G8200 and CRG7400 models.) POWER BURNER
Be sure all surface controls are set in the OFF position prior to supplying gas to the range. Your range is equipped with a pilotless ignition system which eliminates the need for a constant standing pilot light. The spark igniter is located at the back-side of each burnen When cleaning around the surface burner, use care. Ira cleaning cloth should catch the igniter, it could damage or break it. This xx,illprevent the burner from lighting.
Ignitor REAR VIEW OF SEALED BURNER
Lighting the Surface Burners
To light the surface burners: POWER BURNER A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blne with a deeper blue inner core; there should be no trace of yellow in the flame (this indicates an improper mixture of air/gas whicb wastes fuel and should be adjusted by a service technician), With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessaD_ With some types of gas, you may hear a "popping" sound when the surface burner is turned off. This is a normal operating sound of the burner. 1. Place a pan on the burner grate. 2. Push in and turn the knob to the START position. A sparking sound will be beard and the burner will light.
NOTE: All four igniters will spark when any surface burner knob is turned to the START position, 3. Once the burner lights, turn the knob to the desired flame size. The sparking will not stop until the knob is turned from the START position.
