Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
Pull-out Freezer Floor
(on some models)
To remove and replace the freezer floor: 1. Lift both back �fences� up and out. 2. Remove the freezer floor by pulling it out about 1 in. (25.40 mm) with one hand around the air tower section (center back) and one hand at center front. 3. Lift up floor at rear until hooks release from cabinet and pull the floor out the rest of the way. 4. Replace the freezer floor by sliding the floor straight in until the hooks drop into place at rear of cabinet. 5. Replace �fences� by aligning pins with socket in the floor, and pushing down until they snap into place.
Door Bins
(on some models)
To remove and replace the bins: 1. Remove the bin by lifting it up and pulling it straight out. 2. Replace the bin by sliding it in above the desired support and pushing it down until it stops.
Can Rack
(on some models - Accessory)
To remove and replace the rack: 1. Remove the rack by lifting it up and pulling straight out. 2. Replace the rack by holding it above the desired support and pushing the rack back and down until it stops.
DOOR FEATURES
Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word �Accessory.� Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the cover or in the "Assistance or Service" section.
Door Rails
The door rails may be removed for easier cleaning.
Adjustable Utility Compartment & Tray
(on some models)
The utility compartment and tray slide from one side to the other for more flexible storage. The tray fits on either side of the utility compartment or partially underneath it. Try moving it to different positions to find the option that works best for you. To install the utility compartment and tray: 1. Insert the front of the utility tray into the slot on the back of the shelf rail. Lower the back of the tray into position. 2. Place the front of the utility compartment on top of the shelf rail. Lower the back of the compartment onto the ribs on the refrigerator door.
Snap-on Door Rails
To remove and replace the rails: 1. Remove the rails by pushing in slightly on the front of the bracket while pulling out on the inside tab. Repeat these steps for the other end of the rail. 2. Replace the rails by aligning the ends of the brackets with the buttons on the sides of the door liner. Firmly snap bracket and rail assembly onto the tabs above the shelf as shown.
Drop-in Door Rails
To remove and replace the rails: 1. Remove the rails by pulling straight up on each end of the rail. 2. Replace the rails by sliding the shelf rail into the slots on the door and pushing the rail straight down until it stops.
