|
Kto jest w sklepie?
Sklep przegląda 5878 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
SERVICE AND ADJUSTMENTS
TO START ENGINE WITH A WEAK BATTERY (See Fig. 34)
WARNING: Lead-acid batteries generate explosive gases. Keep sparks, �ame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual). If �jumper cables� are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. � Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)
� � � � Raise hood. Unsnap headlight wire connector. Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. To replace, reverse above procedure.
TO ATTACH JUMPER CABLES � Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis. � Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery. � Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery. TO REMOVE CABLES, REVERSE ORDER � BLACK cable �rst from chassis and then from the fully charged battery. � RED cable last from both batteries.
HOOD
HEADLIGHT WIRE CONNECTOR
01536
FIG. 35
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
WEAK OR DEAD BATTERY FULLY CHARGED BATTERY
The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.
FIG. 34
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.
TO REPLACE HEADLIGHT BULB
� � � � Raise hood. Pull bulb holder out of the hole in the backside of the grill. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Close hood.
26
|
|
|
> |
|