ROLAND CUBE-20X
Instrukcja Obsługi

Panel descriptions

EFX (Effects)
11.EFX (Effects) Knob
Turn this knob to chorus, flanger, phaser, or tremolo to select the corresponding effect. Turn the knob to adjust the amount of effect applied. The ON indicator lights up when EFX is turned on, and goes out when EFX is turned off. You can also turn EFX on and off using optional footswitches (BOSS FS-5U or FS-6). * Graduations for CHORUS, FLANGER, PHASER, TREMOLO on a panel are for reference. Be sure to check the sound as you adjust the effects.

REVERB

Turn the knob to adjust the reverb level.

13. POWER SQUEEZER Switch
The switch lights in red when the power squeezer function is on; the switch is unlit when the power squeezer is off. Switching on the Power Squeezer function allows you to reduce the amp�s output to 2 watts. Switching this on allows you to produce a sound that preserves the same tone and balance as when the amp is played at maximum volume, but at an output of 2 watts, for volume levels that are more suitable for the average home. * The Power Squeezer function affects only sounds input through the INPUT jack. It has no effect on sounds input via the AUX IN jack.

CHORUS
In this effect, a slightly detuned sound is added to the original sound, giving the sound greater breadth and fullness.

FLANGER
This creates a flanging effect that creates a sort of spinning sensation with the sound.

14. AUX IN Jack
You can connect a CD player, MP3 player or other kind of device and have it play along with your guitar. This accepts a stereo miniature phone plug. However, the speaker and RECORDING OUT/PHONES output is monaural. * Determine the volume level by adjusting the volume control of the connected device.

PHASER
This effect adds a variable phaseshifted signal to the direct sound, giving the sound a swirling character.

TREMOLO
Tremolo is an effect that creates a cyclic change in volume.

15. FOOT SW (Footswitch) Jack
You can use footswitches (optional BOSS FS-5U or FS-6) connected using a connection cable (optional Roland PCS-31) to switch channels (JC CLEAN/LEAD), and to turn EFX on and off.

DELAY/REVERB
12.DELAY/REVERB Knob
Turn this knob to DELAY or REVERB to switch to that effect.Turn the knob to adjust the amount of effect applied. * Graduations for DELAY, REVERB on a panel are for reference. Be sure to check the sound as you adjust the effects.
PCS-31

red

white

DELAY
Turn the knob to change the time and amount of delay effects.
EFX SELECT Polarity Switch

* When you connect only one footswitch by mono cable, you can only use it to switch channels (JC CLEAN/LEAD).

7