JVC CU-VH1US
Instrukcja Obsługi

42 EN

USING THE REMOTE CONTROL UNIT (cont.)
NOTES: � When editing onto a tape that was recorded at 12-bit, the old and new soundtracks are recorded separately. � If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas. � If feedback or howling occurs during TV playback, move the microphone away from the TV, or turn down the TV�s volume. � If you change from 12-bit to 16-bit in midrecording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began. � During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops. � To perform Audio Dubbing while watching on the television, make connections. ( pg. 20) � To perform Audio Dubbing with a video unit connected to the player�s S2, AUDIO(L/R), VIDEO connector, first set �S/AV INPUT� to �ON� in VIDEO Menu. ( pg. 28, 29) The �AUX� indication appears instead of �MIC�.

Audio Dubbing (DV mode only)
The audio track of a tape recorded in DV format can be customized only when recorded in the 12-bit and SP modes. ( pg. 29)
Microphone

Speaker

Audio cable (provided)

Open the cover. Headphone Connector

1 2 3 4

Play back the tape to locate the point where editing will start, then press PAUSE (9). While holding A. DUB (D) on the remote control, press PAUSE (9). The �9D� and �MIC� indicators appear. Press PLAY (U), then begin �narrating�. Speak into the microphone. � To pause dubbing, press PAUSE (9). To end Audio Dubbing, press PAUSE (9), then STOP (8).

To hear the sound during Audio Dubbing... Connect optional headphones to the headphone connector or use the S2, AUDIO(L/R), VIDEO connector, and set �DV NARR.� to the desired mode; � �OFF� for the playback sound. � �ON� for the dubbed sound. � �MIX� for the playback and dubbed sound. To hear the dubbed sound during playback� Set �DV NARR.� to �ON� or �MIX�. ( pg. 28, 29)