HITACHI CX39EBS
Instrukcja Obsługi

English
1. 2. 3. 4.
C D l y T a p R c d P o w e r

English
MAINTENANCE
¨ CLEANING OF HEADS AND TAPE PATH We recommend cleaning after every 10 hours of operation. To make the best possible recordings, you should clean all surfaces which the tape travels before every recording. 1. 2. 3. Press STOP/EJECT button to op en the cassette holder. Wipe the heads, pinch roller and capstan with cleaning tip slight hoisted with cleaning fluid or alcohol. After cleaning the heads and tape path, do not insert a cassette until the areas cleaned are completely dry.

TAPE ERASING Set FUNCTION SELECTOR (10) to �T APE (CD RADIO OFF) � position. Insert recorded cassette into the cassette deck. Depress RECORD & PLAY button on cassette deck. To stop erasing, press STOP/EJECT button on cassette deck. Copyright may exist in material you wish to record. Copying of such material requires the permission of the owner.

WARNING:

¨ ¨

The recording level is automatically adjusted by built- in ALC circuit. The recording level is not affected by the VOLUME CONTROL (1) AND SURROUND button (3), so you can listen to the program with surround and any level of volume that you want.

CHECK THE FOLLOWING BEFORE CALLING FOR SERVICE
Before you jump to the conclusion that the unit is out of order! When the set is not operating properly, one is apt to assume that the set is faulty. There are, however , many possible faults which are not directly attributable to the set itself. It is rec ommended to check the following before taking the set to a Hitachi dealer. Symptom NO AC power NO DC power Tape does not run when a button is pressed. Cassette can not be inserted. No recording. · · · Sound deterioration or irregular tape speed. Slow tape speed or low volume. Disc is not played. · · · · Player does not operate correctly; sound is interrupted, noise occurs and tracks cannot be selected. Player does not operate normally when control butt ons are pressed. · First, press the Stop button then play the disc again. · · · Is the cassette upside down? Is the Pause button pressed? If so, unlock and release. Are the accidental - erasure prevention tabs punched out? If so, cover the holes with plastic tape. Clean heads, capstan and pressure roller with a cleaning stick. Are the batteries exhausted? Is the disc loaded upside down? Is the disc scratched or warped? Is the pick -up lens dirty? If stick. Is the disc scratched or otherwise flawed? Is the disc soiled? so, clean it with a cleaning · · · · Cause/Method of solution Is the power cord connected properly? Are the batteries properly inserted in the battery compartment? Are the batteries exhausted?

¨ CLEANING THE CABINET Clean the cabinet, panel and controls with a soft cloth light moisted with a mild detergent solution. Do not use any type of adrasive pad, scouring powder or solvent such as alcohol or benzine.

16

17