SOUND ADJUSTMENTS
Setting the clock
1 Hold down SHIFT and press CLOCK on the remote control.
When the unit is turned off, you can also press a or ENTER.
Graphic equalizer
Selects a sound equalization curve to match the music type.
Press EQ repeatedly to select one of the three equalization curves. - ROCK: Powerful sound emphasizing treble and bass - POP: More presence in the vocals and midrange - JAZZ: Accented lower frequencies for jazz-type music To cancel equalization Press EQ repeatedly until the selected levels go off.
Q SURROUND system
The Q SURROUND system built into this unit uses only two speakers at the left and right to create an atmosphere that sounds as if you are surrounded by two front speakers and two rear speakers.
Press QSURROUND until "Q-SUR" appears on the display and the QSURROUND indicator lights up. To cancel the Q SURROUND effect Repeat the above so that the QSURROUND indicator goes off.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units. If f or g is not pressed within 4 seconds, setting is canceled. �You can also turn VOLUME/MULTI JOG to the right to advance the time and to the left to move the time back. The speed with which the time changes varies according to how fast you turn VOLUME/MULTI JOG.
En
BBE
Enhances high frequencies for sound clarity.
Press BBE repeatedly to select one of the three enhancement levels or the off position. �If the sound becomes distorted with the BBE effect, cancel the effect.
3 Press a or ENTER.
To display the time while the power is on The time display stops flashing and the clock starts from 00 seconds.
Tip: �The Q SURROUND system does not work in monaural mode. �When the Q SURROUND system is on, the sound may be distorted at higher volumes. If this happens, turn the volume down.
T-BASS
Emphasizes low frequencies for a powerful sound.
Press T-BASS repeatedly to select one of the three emphasis levels or the off position. �If the sound becomes distorted with the T-BASS effect, cancel the effect.
Hold down SHIFT and press CLOCK on the remote control. The time will be displayed for 4 seconds. To switch to the 24-hour standard Display the time and press s within 4 seconds. With each press, the clock alternates between 12- and 24hour standard time.
Tip: In the 12-hour standard, "AM12:00" indicates midnight and "PM12:00" noon.
If the clock display flashes when the unit is turned off There has been a power interruption. Reset the clock.
