Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
9. At the end of the washing programme
At the end of the programme the dishwasher will automatically stop. The On/Off indicator light remains on until the On/Off push button is depressed.
2. Check that there is rinse aid and salt 3. Load the dishes
Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off push button. Wait 15/20 minutes before opening the dishwasher�s door; in this way you will avoid burning yourself when removing the dishes and avoid also the damage of the nearby furniture caused by the escape of steam. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
4. Ensure that the spray arms can rotate freely. 5. Measure out detergent
Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. Close the detergent dispenser lid.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
6. Close the dishwasher door
Important! Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
7. Set the programme
Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel.
8. Start the programme
Depress the On/Off push button. The On/Off indicator light will come on and the machine will start.
