Checking the battery *
Check icon at the bottom of the screen
I
Low battery power
The blocks on the display show the charge of your battery pack. Full battery power
DO NOT connect a charger or any other external DC source if the phone's battery is not inserted.
Low battery alarm
When the battery voltage falls below the working level, Recharge Battery is displayed on screen along with a flashing empty battery icon and a warning tone. The phone will automatically power down shortly afterwards.
O
To cancel the battery alarm, press any key except . The low battery alarm will repeat until the phone automatically switches off.
2
Changing the battery
Make sure the phone is switched off. Some settings may be lost if the battery is removed while the power is on.
1
3
* *
Slide the battery catch towards the top of the phone � and lift the battery out �. Put the new battery pack in base first then lower it into place � .
Charging a battery
The charger unit begins to restore the battery power when it is connected to the phone.
O I
It may take a few seconds for the indication to start. Using the wrong type of charger can be dangerous and may invalidate any warranty and approval given to the cellphone. Do not connect more than one charger at any time. Do not leave the charger connected to the mains supply when it is not in use.
Charger connector
When charging is complete, the battery icon will stop pulsing and trickle charging continues. During charging the battery icon pulses and shows as a solid block when charging is complete. This is also shown when the phone is switched off. If you need to receive calls, the cellphone can be switched on and left in standby while it is charging, although the total time taken to charge is then increased. The cellphone is designed to be charged with the NEC equipment listed with the specifications of your phone.
*
Connect the charger plug into the connector at the base of the phone. Check the battery icon is pulsing.
