Troubleshooting
Problem Cause The handset is out of range, ( is not displayed). The handset has not been registered to the base station ( is not displayed). Solution Move closer to the base station and try again Register the handset to the base station (page 5)
No dial tone.
The base station is not Check the connections properly connected to the mains or the telephone line. The batteries are low ( displayed). When the handset is placed on the charging unit, no beep is heard. is Charge batteries (page 4)
The charging unit is not properly Check the connection between connected to the mains. charging unit and mains. Charging contacts are dirty. Key tones are deactivated. Clean with a clean & dry cloth. Activate them (page 10)
The batteries remain low although they have charged for 12 hours.
The charging unit is not properly Check the connection connected to the mains. Handset not registered to base Register handset to base (page 5) Contact your dealer. Purchase new batteries Retry when the current call is finished. Wait until it is available Move closer to the base Charge the batteries. Activate it (page 10). Try the procedure again (page 5). Un-register a handset (page 5)
The batteries are defective or too old. An error beep is heard from Another call is already in the handset when trying to progress from another handset make a call. or the base station. The base is being consulted An error beep is heard The handset is out of range. during a call. The handset batteries are low There is no ringer. When adding a handset to the base station, a failure message is displayed. The ringer is deactivated The procedure has failed The maximum number of handset has been reached. You are too far from the base. The base station is too close to electrical appliances, reinforced concrete walls or metal door frames Troubleshooting
Interference during call.
Get closer to the base station. Move the base station to find a better place (the higher the better).
