Installation
DIN Rear-mount
1 Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.)
Trim ring
! It becomes easy to remove the trim ring if the front panel is released.
2 Determine the appropriate position where the holes on the bracket and the side of the unit match.
3
Tighten two screws on each side.
Screw
Mounting bracket
Dashboard or console
! Use either truss screws (5 mm � 8 mm) or flush surface screws (5 mm � 9 mm), depending on the shape of screw holes in the bracket.
