PIONEER DEHP7100R
Instrukcja Serwisowa

Audio Adjustment
Subwoofer Setting Adjustment (Sub-W2)
When the Subwoofer output is ON, you can adjust the cut-off frequency and the output level of Subwoofer.

1. Press the AUDIO button and select the Subwoofer setting mode (Sub-W2) in the Audio Menu. 2. Select the frequency to 50 Hz, 80 Hz or 125 Hz with the 2/3 buttons. 3. Increase or decrease the output level with the 5/� buttons.
The display shows �+ 6� � �� 6�. Note:
� You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the Subwoofer ON/OFF mode.

Non Fading Output (NonFad)
When the Non Fading Output setting is ON, the audio signal does not pass through this unit�s low pass filter (for the Subwoofer), but is output through the RCA output. Note:
� When the Subwoofer Controller setting is only �S.W Control:EXT�, you can switch the Non Fading Output ON/OFF mode. (Refer to page 52.)

1. Press the AUDIO button and select the Non Fading Output ON/OFF mode (NonFad) in the Audio Menu. 2. Switch the Non Fading output ON/OFF with the 5/� buttons.

43