PIONEER DEH-P7950UB/XN/ES
Instrukcja Obsługi

Section

02

Operating this unit
+6 to �4 (or �6) is displayed as the equalizer curve is increased or decreased.
# The actual range of the adjustments are different depending on which equalizer curve is selected. # The equalizer curve with all frequencies set to 0 cannot be adjusted.

+6 to �6 is displayed as the level is increased or decreased.
# You can then select another band and adjust the level.

5 Press BAND to cancel the 7-band graphic equalizer adjustment.

Adjusting 7-band graphic equalizer
For Custom1 and Custom2 equalizer curves, you can adjust the level of each band. ! A separate Custom1 curve can be created for each source. (The built-in CD player and the multi-CD player are set to the same equalizer adjustment setting automatically.) If you make adjustments when a curve other than Custom2 is selected, the equalizer curve settings will be memorized in Custom1. ! A Custom2 curve can be created common to all sources. If you make adjustments when the Custom2 curve is selected, the Custom2 curve will be updated. 1 Recall the equalizer curve you want to adjust. See Recalling equalizer curves on the previous page. 2 Use MULTI-CONTROL to select 7-band graphic equalizer adjustment. Frequency and the level (e.g., 50Hz +4) appears in the display. 3 Push MULTI-CONTROL left or right to select the equalizer band to adjust. Each time MULTI-CONTROL is pushed left or right, equalizer bands are selected in the following order: 50Hz�125Hz�315Hz�800Hz�2kHz� 5kHz�12.5kHz 4 Push MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pushed up or down, the level of the equalization band increases or decreases.

Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Use MULTI-CONTROL to select LOUD.

2 Press MULTI-CONTROL to turn loudness on. Loudness level (e.g., Mid) appears in the display.
# To turn loudness off, press MULTI-CONTROL again.

3 Push MULTI-CONTROL left or right to select a desired level. Each time MULTI-CONTROL is pushed left or right, level is selected in the following order: Low (low)�Mid (mid)�High (high)

Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. 1 Use MULTI-CONTROL to select Sub W.1.
# You can also select the subwoofer setting menu by pressing SW on the unit.

2 Press MULTI-CONTROL to turn subwoofer output on. Normal appears in the display. Subwoofer output is now on.
# To turn subwoofer output off, press MULTI-CONTROL again.

26

En