PIONEER DEH-P9850BT/XN/ES
Instrukcja Obsługi

Section

Audio Adjustments

13

� When delays occur for low sounds due to the influence of the LPF on active subwoofers or external amps. ! Auto TA and EQ changes the audio settings as below: � The fader/balance settings return to the center position. (Refer to page 72.) � The graphic equalizer curve switches to Flat. (Refer to page 76.) � When a subwoofer is connected to this unit, it will be adjusted automatically to both subwoofer output and high pass filter setting for rear speaker. ! If you carry out auto TA and EQ when a previous setting of this already exists, the setting will be replaced.

3 Turn the ignition switch to ON or ACC. If the car�s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto TA and EQ.
# Press SOURCE to turn the source on if this unit is turned off.

Carrying out auto TA and EQ
Never use the microphone for hands-free phoning to operate the auto TA and EQ. Using the microphone unfit for the auto TA and EQ may damage the speaker. Be sure to connect the AUTO TA&EQ microphone into the microphone input jack.

4

Select the position for the seat on

CAUTION

which the microphone is placed. Refer to Using the position selector on page 72.
# If no position is selected before you start auto TA and EQ, Front Left is selected automatically.

5 Press SOURCE and hold until the unit turns off. If anything is connected to the microphone input jack, disconnect it. 6 Press and hold EQ to enter the auto TA

1

Stop the car in a place that is as quiet

as possible, close all doors, windows and the sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct auto TA and EQ. 2 Fix the supplied microphone in the center of the headrest of the driver�s seat, facing forward, using the belt (sold separately). The auto TA and EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat to carry out auto TA and EQ.

English

and EQ measurement mode. 7 Plug the microphone into the microphone input jack on this unit.

AUTO TA&EQ microphone En

81