2 Press 2 or 3 to select the speaker to be adjusted. Each press of 2 or 3 selects the speaker in the following order: Front speaker left�Center speaker�Front speaker right�Rear speaker right�Rear speaker left�Subwoofer � You cannot select speakers whose size is set OFF. 3 Press 5 or � to adjust the speaker output level. Each press of 5 or � increases or decreases the speaker output level. � +10 � �10 is displayed as the level is increased or decreased. 4 Press BAND/ESC to return to the playback display. Note � To adjust the speaker output levels at this mode is the same as making the speaker output levels at T Tone. Both provide the same results.
2 Press 3 to start the test tone output. The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about 2 seconds. The current settings for the speaker over which you hear the test tone are shown in the display. Front speaker left�Center speaker�Front speaker right�Rear speaker right�Rear speaker left�Subwoofer Check each speaker output level. If no adjustments are needed, perform step 4 to stop the test tone. � The settings do not appear for speakers whose size is set OFF. 3 Press 5 or � to adjust the speaker output level. Each press of 5 or � increases or decreases the speaker output level. � +10 � �10 is displayed as the level is increased or decreased. � The test tone rotates to the next speaker after about 2 seconds from the last operation. 4 Press 2 to stop the test tone output. 5 Press BAND/ESC to return to the playback display.
Adjusting the speaker output levels using a test tone
A convenient test tone allows you to easily get the overall balance right among the speakers. 1 Press AUDIO and hold until SP Set appears in the display, then press AUDIO to select T Tone. After SP Set is displayed, press AUDIO until T Tone appears in the display.
Notes � If needed, select speakers and adjust their �absolute� output levels, see Adjusting the speaker output levels on page 11. � To adjust the speaker output levels at this mode is the same as making the speaker output levels at SP Lev. Both provide the same results.
