PANASONIC DMRES40V
Instrukcja Obsługi

Reference
Operation
Cannot operate the TV. Cannot operate the DVD. Cannot operate the VHS. The remote control doesn�t work.

DVD
�Change manufacturer code. Some TVs cannot be operated even if you change the code. �Press [TV/VIDEO] to change the input mode to �TV�. �Press [DVD] when operating DVD. �Press [VHS] when operating VHS.

VHS
Page
18 25, 49 10 10 18 10 10 � � � � � �

�The remote control code is wrong. Change to the correct code. �The batteries are depleted. Replace them with new ones. �Point the remote control at the remote control sensor on the main unit. �Remove obstacles between the remote control and main unit. �Don�t place the signal sensor in direct sunlight or in areas that may be subject to sunlight exposure. �If you repeatedly insert discs or turn the unit on and off about 50 times or more, the recording or editing of DVD-R, DVD-RW (DVD-Video format), +R may be disabled. �Some operations are prohibited by the disc. �The unit is warm (�U59� appears on the unit�s display). Wait until �U59� disappears. �One of the unit�s safety devices may have been activated. Reset the unit as follows: (1) Press [POWER �/I] on the main unit to switch to standby. If the unit doesn�t switch to standby, press and hold [POWER �/I] on the main unit for about 10 seconds. The unit is forcibly switched to standby. Alternatively, disconnect the AC power supply cord, wait for about 1 minute, then reconnect it. (2) Press [POWER �/I] to turn the unit on. �The unit is recording. �The unit may have a problem. While the unit is off, hold down [�] and [CH, W] on the main unit simultaneously for about 5 seconds. Remove the disc and consult the dealer. �Make sure that �Quick Start� is set to �On�. Even if �Quick Start� is set to �On�, startup is slow if the clock is not set, there was a power failure or the AC plug has just been connected. �A few dozen seconds after turning on the unit, you can play a disc or start recording to discs other than DVD-RAM. �Startup takes time for a few minutes after 4:00 a.m. due to system maintenance of this unit. �It may take time to read a disc if it is being used for the first time in this unit or it has not been used for a long time.

The unit is on but cannot be operated.

Cannot eject a disc.

� � 41

Startup is slow

� � �

Takes time to read DVD-RAM

Picture
TV reception worsens after connecting the unit. �This can occur because the signals are being divided between the unit and other equipment. It can be solved by using a signal booster, available from audio-visual suppliers.

Page
� 12, 14 � �

The images from the unit do not �Make sure that the TV is connected to the VIDEO OUT terminal, S-VIDEO OUT terminal or appear on the TV. COMPONENT VIDEO OUT terminals on the unit. �Make sure that the TV�s input setting (e.g., VIDEO 1) is correct. Picture is distorted. �The TV isn�t compatible with progressive signals. Press and hold [CANCEL] on the remote control or press and hold [�] and [� DVD, DUBBING] at the same time on the main unit until the picture is displayed correctly. The setting will change to interlace. �Make sure that progressive output has not been selected when the connected TV is not progressive compatible. Press and hold [CANCEL] until the picture displays correctly. The setting will return 480i.

�

62
VQT0R73