Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
ENGLISH
Splice
� Use this function to skip a section between A and B points. The A point is the point from which jumping starts, the B point the point at which jumping ends. � The A1 and A2 Hot Starts and Stutter functions cannot be used if both Splice points are set in the Splice mode.
t
w, r, t e
q
Splice point setting mode
A / B TRIM
Start splice playback
1
q Push the SPLICE button for more than 1 sec to enable setting Splice point using A1, A2 and B buttons.
4
SPLICE
Start playback from any point before point A. When point A is reached, the section from point A to point B is jumped seamlessly and playback continues. Temporarily turning off the splice playback r When the corresponding A button is pushed after setting splice points A and B, the A button illumination turns off and the Splice play mode is temporarily turned off. � Push the corresponding A button again to resume splice playback. Clearing the splice points t While pressing the FLIP/(CLR) button, push the corresponding A button to clear splice points A and B.
� The A button illumination flashes when the Splice mode is set. � The Splice point setting cannot be set for the A point at which Hot Start data is already loaded. Set splice start point A w After starting playback, push the A1 or A2 button. The corresponding A button lights up and that point is set as splice start point A, and B LED start flashing. Set splice end point B
5
2
3
e After setting splice start point A, push the B button. The B LED lights up and that point is set as splice end point B.
6
� When the splice points are cleared, the A button is set back to the Hot Start mode.