|
Dla tego produktu nie napisano jeszcze recenzji!
http://getMANUAL.com
Deleting an edit point
To delete an edit point, use the following procedure. You can use the same procedure whether or not the DELETE button is flashing.
6-1-5 Cue-up to Edit Points and Preroll
To preroll to an edit IN point or cue up to any edit point, use the following procedure.
2
1
1
1
2
1
Press the RECORDER button or PLAYER button to select the VTR on which you wish to delete the edit point. The button you have pressed lights.
Press the RECORDER button or PLAYER button to select the VTR on which you wish to operate. The button you have pressed lights.
2
Hold down the DELETE button and press the IN button or OUT button according to the edit point you wish to delete. The IN point or OUT point is deleted according to which button you pressed, and the DELETE button goes off.
2
� To cue up to an edit point Hold down the IN button or OUT button according to the edit point to which you wish to cue up, and press the PREROLL button. This cues up to the edit point you have selected. � To preroll Press the PREROLL button. The tape is wound back to a position 5 seconds before the edit IN point, and stops.
To restore a deleted edit point To restore an edit point immediately after deleting it, hold down the IN button or OUT button according to the edit point you wish to restore, and press the RECALL button.
To change the preroll time The factory default setting for the preroll time is 5 seconds, but you can use basic menu item 001 to change this to any value from 0 to 30 seconds. If you change the preroll time, make sure that the setting is not longer than the recording length before the edit IN point. Note that for automatic editing, the preroll time setting on the recorder takes precedence.
For more information about the basic menu, see Section 7-2, �Basic Menu� (page 7-1).
Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
Chapter 6
Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
6-5
|
