Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a desired order. (up to 20 tracks)
14
Preparation
÷ Load a disc in the CD player.
@
The figure shows an example for the DPF-2030
0
7
4 1
6
¢ ¡
: Keys and control used in the operations described on this page.
1 Press so that the �PGM� indicator lights.
Do this operation in the stop mode.
P.MODE
0
Lights up.
TRACK PGM NO.
Go to step 2 within 5 seconds.
01
2 Program desired tracks.
1 Select the desired track No.
Main unit
(Except for DPF-2030)
Remote control unit
(Except for DPF-1030)
Displays the entered program No. for a few seconds.
Displays the total playing time of the programmed tracks.
(Programming is not possible during playback)
Press the numeric keys as shown below.... To enter track No. 15: 05
1 2 3 4 5 6
TRACK NO.
TRACK NO.
TOTAL
TIME
4
¢
02
P_ 01
02
_1 6 : 4 2
7
8
9
0
+10
Go to step 2 within 5 seconds.
2 Set the entry.
P.MODE
0
3 Repeat steps 1 and 2 above.
÷ Up to 20 tracks can be programmed. When �FULL� is displayed, no more tracks can be programmed. ÷ If you make a mistake, press the CLEAR key and enter the track No. from the beginning. ÷ When the total playing time of the programmed tracks exceeds 100 minutes, the remaining time on the disc will not be displayed any more.
3 Start playback.
0
6
÷ When the 4 or ¢ key is pressed during playback, the track will be skipped in the direction of the pressed button. ÷ When the 4 key is pressed once during playback, the play position returns to the beginning of the current track being played.
