Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
3.1.3 Remove the mechanism assembly (See figure 5) � Prior to performing the following procedure, remove the cover. � There is no need to remove the front panel assembly. (1) Disconnect the socket wire from connector CN451 on servo control board. (2) Disconnect the card wire from connector CN2201 on digital board. (3) Remove the four screws C attaching the mechanism sembly.
top
Mechanism assembly Digital board C C
the the as-
CN2201 C
3.1.4 Remove the digital board (See figure 6, figure 7) � Prior to performing the following procedure, remove the top cover. (1) Disconnect the card wire from connector CN2201 on the digital board. (2) Remove the four screws D and E attaching the digital board. (3) Remove the one screw F attaching the jack board. (4) Lift the digital board up, and remove it. Then, the digital board is removed from the connectors CN4101, CN4102 on the main board. In attaching the digital board, insert the connector on the digital board in these connectors securely.
