FUNAI DRV-A2677
Instrukcja Serwisowa

(4) Bottom of the flat pack-IC is fixed with glue to the CBA; when removing entire flat pack-IC, first apply soldering iron to center of the flat pack-IC and heat up. Then remove (glue will be melted). (Fig. S-1-6) (5) Release the flat pack-IC from the CBA using tweezers. (Fig. S-1-6) Note: When using a soldering iron, care must be taken to ensure that the flat pack-IC is not being held by glue. When the flat pack-IC is removed from the CBA, handle it gently because it may be damaged if force is applied.

2. Installation
(1) Using desoldering braid, remove the solder from the foil of each pin of the flat pack-IC on the CBA so you can install a replacement flat pack-IC more easily. (2) The �I� mark on the flat pack-IC indicates pin 1. (See Fig. S-1-7.) Be sure this mark matches the 1 on the PCB when positioning for installation. Then presolder the four corners of the flat pack-IC. (See Fig. S-1-8.) (3) Solder all pins of the flat pack-IC. Be sure that none of the pins have solder bridges.
Example :

Hot Air Blower

or

Iron Wire

Pin 1 of the Flat Pack-IC is indicated by a " " mark.

Fig. S-1-7

Soldering Iron To Solid Mounting Point
Fig. S-1-5
Presolder

CBA

Fine Tip Soldering Iron
Flat Pack-IC CBA

Fig. S-1-8
Flat Pack-IC Tweezers

Fig. S-1-6

1-4-3

DVD_NOTE