NOBELS DT-SN
Instrukcja Obsługi

Owners-Manual

Operation:
-

Insert a 9V battery (2) or connect a regulated 9V power supply adaptor to the DC jack (4). Connecting an instrument to the input jack (3) will automatically switch the unit on. Connect your amplifier to the output jack (6). Select your desired sound with the 5 control knobs (7, 8, 9, 10,11). (see Sound examples) Adjust the treshold of the internal noise gates with control knob N-Gate (13). Pressing the pedal (1) switches the unit on or off.

DT-SN
Specifications
Power Consumption Input impedance Output impedance Max. input Controls Jacks Remote Display Dimensions Weight 9V dry battery / AC adaptor max. 22mA 1Mohm 2Kohm +6dBm Drive, Lo, Mid, Hi, Level, N-Gate Input, DC, Remote, Output momentary switch green LED indicator 74mmx126mmx58mm 480g (without Battery)
KTA 980411-2250

-

Instead of using this unit on the frontstage, you can place it with your equipment and control it with a standard momentary footswitch connected to the remote jack (5). Before changing the battery (2) always unplug the input jack (3) to switch the unit off. We suggest to use a regulated 9V power supply adaptor to keep our environment clean. Power supply specifications: see imprint on bottom of unit. - Thank you.

-

Important notes:
Avoid using this unit in extreme humidity, heat or dust environment. When the unit is not in use for longer periods, remove the battery (2) to prevent damages by battery leakage. Also unplug the input (3) to prevent wasting battery life when the unit is not in use.

Specifications are subject to change without notice!

Sound Examples:

DRIVE

BASS

MID

TREBLE

LEVEL

Function:
(3) IN jack: Inserting a plug switches the unit on. (4) 9V DC jack: Connect a regulated 9V power supply unit. (5) REMOTE jack: The ON / OFF-function can be remote controlled by a momentary switch, connected to the REMOTE jack (5). Intelligent switching devices (like the Nobels MF-2 or MS-4) also can remote control the unit. (6) OUT jack: This output delivers a low impedance output signal best for the input of your amplifier.

-1 Rock

-2 Hardrock

-3 Hardcore

(7) DRIVE control: Adjust this control to get sounds from slight crunch to full overdrive. (8) LO control: Adjust this control to get more or less bass. (9) MID control: Adjust this control to get more or less amount of mid-frequencies.

-4 Heavy Metal

(10)HI control: Adjust this control to get more or less hi-frequencies. (11)LEVEL control: Adjusts the volume. (12)LED: This Led shows the state of the effect. LED on = Effect on.

-5 Speed Metal

(13)N-Gate Regler: Adjust this control to select the desired treshold of the internal noise gate.