|
Kto jest w sklepie?
Sklep przegląda 5987 gości i 3 zarejestrowanych klientów
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
1�
e results, the
,
. water
A liquid rinse aid dispenser (select models) automatical(y releases a measured amount portion of each cycle. of rinse aid into the final rinse
1 .Use
Hot Water
to dissolve & activate detergent, dissolve greasy food soils and improve drying,
temperature should be 120-140°F. Check the water temperature by turning on the hot water faucet nearest the dishwasher and letting it run into a glass in the sink. Place a candy thermometer in the glass and check the temperature once it has stopped rising, If it is below 120°F have a qualified son raise the water heater setting. per-
For best
incoming
2.Use e Rinse regularly to
drying reduce filming.
Aid improve results and spotting and
To fill the dispenser, turn the cap counterclockwise to open. Pour the rinse aid into the reservoir. Replace the cap and be sure it is securely in place before closing the dishwasher door. Check the dispenser monthly and refill as needed.
Helpful Hints: � If the outside temperature is unusually low, or if your water travels a long distance from the water heater to the dishwasher, you may need to increase your home's water heater setting and/or select water heating options on your dishwasher, � If you have not used hot water for awhile, the water in the pipes will be cold. Turn on the hot water faucet at
Use a detergent
designed
specifically
3.Use
the Proper Detergent Amount for best soil removal, good drying results and prevention of filming, etching, and spotting,
for use in an automatic dishwasher. Other types (laundry, hand soap, etc,) will cause over sudsing. Be sure to use fresh detergent and store it in a cool, dry place (not under the sink). The amount of detergent to use depends on the water hardness (measured in grains per gallon-gpg) and the amount of soil on the dishes. Generally detergent amounts should be increased for harder water and heavier soil.
4. Load
Properly to ensure soiled
sur�
the sink and allow it to run until the water is hot. Start the dishwasher,
faces get adequate wash action. (See page 3). 5.Select the Proper Cycle/Options based on the amount of food soil onthe load. (See page 4).
If you've recently done laundry or run hot water for showers, your water heater may need time to recover before operating the dishwasher,
A basic guideline is one teaspoon (tsp.) of detergent for each grain of water hardness. Use a minimum of three teaspoons in soft water.* When using a concentrated detergent decrease the amount by half. If the water hardness is 15 grains or harder, it will be virtually impossible to get good results with any dishwasher. The only solution is a mechanical water softener to improve water quality and detergent effectiveness.
Rinse aids come in solid or liquid form. When using a solid rinse aid, fasten it to the back right corner of the lower rack, Purchase more rinse aid when the material dissolves and the container is empty,
CYCLES
Super Scrub Heavy Normal Short Rinse & Hold
0
|
|
|
> |
|