You can change a cycle setting anytime during any cycle. 1. Lift up the door latch to stop the cycle. 2. Turn the Cycle Control Knob clockwise to the desired cycle. 3. Check the detergent dispensers. They must be filled properly for the new cycle. NOTE: Turning the Cycle Control Knob can cause the covered section of the detergent dispenser to open and release the detergent. Check the covered section if setting Normal Wash or Pots & Pans cycle. 4. Close the door firmly until it latches. The dishwasher starts the new cycle.
Adding
(on some
an item
models)
during
a cycle
You can add an item to the dishwasher anytime before the Cycle Control Knob reaches Light Wash. Items added after the Cycle Control Knob reaches Light Wash will only be rinsed. 1. Lift up the door latch to stop the cycle. Wait for spraying action to stop before opening the door. 2. Open the door and add the item. 3. Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. Doing so reduces the amount of moisture in the vent when restarting a cycle. 4. Close the door firmly until it latches. The dishwasher resumes the cycle.
