WHIRLPOOL DU840CWDQ2
Instrukcja Obsługi

Changing
(on some

a cycle

setting

models)

You can change a cycle setting anytime during any cycle. 1. Lii up the door latch to stop the cycle. 2. Turn the Cycle Control Knob cbckwise to the desired cycle. 3. Check the detergent dispensers. They must he filled properly for the new cycle. NOTE: Turning the Cycle Control Knob can cause the covered section of the detergent dispenser to open and release the detergent. Check the covered section if setting NORMAL WASH or POTS 8 PANS cycle. 4. Close the door firmly until it latches. The dishwasher starts the new cycle.

Adding
(on some

an item during
models)

a cycle

You can add an additional item to the dishwasher anytime before the Cycle Control Knob reaches LIGHT WASH. Items added after the Cycle Control Knob reaches LIGHT WASH will only he rii. 1. Lii up the door latch to stop the cycle. Wait for spraying action to stop before opening the door. 2. open the door and add the item. 3. Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. Doing so reduces the amount of moisture in the vent when restarting a cycle. 4. Cbse the door firmly until it latches. The dishwasher resumes the cycle.

14