PHILIPS DVD701AT
Instrukcja Obsługi

Connecting the power cord
+ +

1 Plug the female end of the supplied power cord into the Mains (AC) jack 2
on the rear of the player. Connect the other end of the cord to an AC outlet. Note: When the player is in the �STANDBY� mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press POWER ON/OFF Caution: Only qualified service personnel should remove the cover or attempt to service this device.

Remote control battery installation
Loading the batteries

1 Open the battery compartment cover. 2 Insert batteries as indicated inside the battery compartment. 3 Close the cover.
Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television�s on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below.

1 Press the POWER ON/OFF button on the front panel of the DVD 2 3 4
player to turn OFF the DVD player. Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF. After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting. To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.

16 PREPARATION