Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Mechanical Instructions 4.7 Sledge Motor Assembly
Caution: Never try to align or repair the DVD-Module itself! Only the factory can do this properly. Service engineers are only allowed to exchange the sledge motor assy. � Place the DVD-Module, with the laser facing downwards on a soft surface. � Remove the three screws that hold the sledge-motor assy and lift the assy upwards. You can replace it now.
VAD 8031
4.
EN 7
Figure 4-6 Remove Sledge Motor Assy
4.8
Re-assembly
To re-assemble the module, do all processes in reverse order. Take care of the following: � Sledge-motor assy: Mesh the teeth of the sledge motor and sledge rack properly, during mounting of the sledge motor assy. � Heat Paths: Put the 5 heat paths (gray rubber pieces) back to their position on the ICs, see figure 4-7. � Complete module: Place all wires/cables in their original positions � Emergency opening slot: Be sure that the slot for the emergency tray opener is covered by adhesive tape! � Jumper selection: Jumper has to be in position "Master"!