SAMSUNG DVD-V5450XEH
Instrukcja Serwisowa

Operating Instructions

Protecting a Recorded Cassette
Video cassettes have a safety tab to prevent accidental erasure. When this tab has been removed, you cannot record on the tape.

Recording a Programme Immediately
Before recording a programme, you must have preset the corresponding station (unless you are recording via an external video source). If you have not done so, refer to pages 17~18.

1

If you wish to protect a cassette, break off the tab using a small screwdriver.

Switch on the television.

1 2 3
To monitor the programme being recorded, select the television channel reserved for use with your DVD-VCR (or the AV input if used).

Insert the cassette on which the programme is to be recorded, with the window visible and the safety tab intact or the opening covered with adhesive tape. The DVD-VCR is switched on automatically. Select the station to be recorded by pressing the PROG or button or select the source (AV1, AV2, or AUX) by pressing the INPUT SEL. button for a satellite tuner or external video source. The station number is displayed and the programme can be seen on the television.

VCR Functions

2

To re-record over a protected cassette (safety tab broken), cover the hole with adhesive tape.

4

5 6

Select the recording speed by pressing the SPEED button as many times as required (refer to page 26).

Hold down the REC (�) button for a while to start recording. The record indicator appears on the television and DVD-VCR display. An index is recorded on the tape (refer to page 37).

7

To stop recording, press the � button once. � If your DVD-VCR ejects the cassette when you start recording, check to make sure that the cassette�s safety tab is intact or that the opening (created by a broken safety tab) is overed with adhesive tape. � If you reach the end of the tape while recording, the cassette rewinds automatically.

English - 27
12-22 Samsung Electronics