PIONEER DVH-P590MP
Instrukcja Obsługi

Section

Operating this unit

03

+6 to �4 (or �6) is displayed as the equalizer curve is increased or decreased.
# The actual range of the adjustments are different depending on which equalizer curve is selected. # The equalizer curve with all frequencies set to 0 cannot be adjusted.

+6 to �6 is displayed as the level is increased or decreased.
# You can then select another band and adjust the level.

5 Press BAND to cancel the 7-band graphic equalizer adjustment.

Adjusting 7-band graphic equalizer
For CUSTOM 1 and CUSTOM 2 equalizer curves, you can adjust the level of each band. ! A separate CUSTOM 1 curve can be created for each source. If you make adjustments when a curve other than CUSTOM 2 is selected, the equalizer curve settings will be memorized in CUSTOM 1. ! A CUSTOM 2 curve can be created common to all sources. If you make adjustments when the CUSTOM 2 curve is selected, the CUSTOM 2 curve will be updated. 1 Recall the equalizer curve you want to adjust. See Recalling equalizer curves on the previous page. 2 Press AUDIO to select 7-band graphic equalizer adjustment. Frequency and the level (e.g., 50HZ 0) appears in the display. 3 Press c or d to select the equalizer band to adjust. Each press of c or d selects equalizer bands in the following order: 50Hz�125Hz�315Hz�800Hz�2kHz� 5kHz�12.5kHz 4 Press a or b to adjust the level of the equalizer band. Each press of a or b increases or decreases the level of the equalization band.

Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select LOUD.

2 Press a to turn loudness on. Loudness level (e.g., LOUD MID) appears in the display.
# To turn loudness off, press b.

3 Press c or d to select a desired level. LOW (low)�MID (mid)�HIGH (high)

Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. 1 Press AUDIO to select SUB.W.

# You can also select the subwoofer setting menu by pressing SW on the unit.

Operating this unit
En

2 Press a to turn subwoofer output on. SUB.W NOR appears in the display. Subwoofer output is now on.
# If the subwoofer output phase has been set to the reverse, SUB.W REV will be displayed. # To turn subwoofer output off, press b.

3 Press c or d to select the phase of subwoofer output. Press c to select reverse phase and REV appears in the display. Press d to select normal phase and NOR appears in the display.

43