Tekstowy podgląd strony 137 (kliknij aby zobaczyć)
5
6
7
8
Notes on Lead Dressing Control Panel Section
A
Notes: � Fold one end of the flat cable along a line 13 mm from the edge. � The folded end of the cable must be inserted to connector B. � Connect the end not folded first to connector A then the folded end to B. � NEVER fold the cable at the A end. Push the cable downward.
Notes: � Fold one end of the flat cable at the end of the reinforcing plate. � The folded end of the cable must be inserted to connector B. � Connect the end not folded first to connector A then the folded end to B. � Fold the flat cable at point C so that the fold forms a right angle. � Never fold the cable at the A end.
C A
CN3002 (DIPB Assy)
B
B
CN4001 (JFLB Assy)
B
CN3005 (DIPB Assy)
A
CN3002 (DIPB Assy)
B A
CN4001 (JFLB Assy) CN4201 (KSWB Assy)
C
Note: � Fold both ends of the flat cable, each along a line 15 mm from the edge. Push the cable downward.
D
CN3004 (DIPB Assy)
CN3300 (SLDB Assy)
Notes: � Fold one end of the flat cable along a line 13 mm from the edge. � The folded end of the cable must be inserted to connector A.
