SONY DVPC600D
Instrukcja Obsługi

6-5. Drive Auto Adjustment
The drive can be automatically adjusted, except disc change and tangential skew adjustment. For a disc, use the disc for adjustment. In case of abnormality, press the [STOP] key to stop adjustment. If the drive does not stop, prevent secondary failure by taking proper action such as disconnection of the power cable. This adjustment should be made after repair is finished and no trouble is present in the drive. A trouble, if present, causes NG and the adjustment to be aborted. As the secondary failure could occur, perform automatic adjustment after the drive is completely repaired. With the initial menu displayed, press [1] on standard commander, and the screen as shown in Figure 8 will appear.
Drive Auto Adjustment SA.00000 SI.00 EMG.OO

The tray opens after the [ENTER] key is pressed and the initialization is finished. Then, place the disc for adjustment. If �ALL� is selected, place three discs, DVD_SL, CD and DVD_DL for adjustment. Press the [ENTER] key to start adjustment. During adjustment, the tangential skew adjustment screen is displayed. Make this adjustment only when the pickup was replaced. As for adjustment, rotate the T-SKEW adjusting screw on the pickup so that the displayed jitter becomes minimum (CCW makes jitter smaller). Avoid extreme rotation or interference of screwdriver with the disc. After all of the adjustments are finished, turn off the power and unplug. Then apply a drop of locking agent to the recess of screw. Note that if �All� is selected, the data of previous adjustment are erased and initial values are set.

T-SKEW adjusting screw

Select No. 0: All 2: DVD SL

�Blinking 3: 4: CD DVD-DL

STOP:

Press STOP Key

Figure 8

If �All� is selected, the screen shown in Figure 9 is displayed.
Drive Auto Adjustment SA.00000 SI.00 EMG.OO

Figure 10

0:

Adjustment ALL 0: All 2: CD 2: DVD SL 3: DVD-DL

START: Press ENTER Key STOP: Press STOP Key

�Blinking

Figure 9

6-10