Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 70 (kliknij aby zobaczyć)
3 Controlling Your TV or AV Amplifier (Receiver) With the Supplied Remote
By adjusting the remote signal, you can control your TV with the supplied remote. If you connect the player to an AV amplifier (receiver), you can control the volume with the supplied remote.
[/1
Release [/1.
When the TV/DVD switch is set to TV, the remote performs the following:
Turns the TV on or off Adjusts the volume of the TV Switches to or from the wide mode of a Sony wide TV Switches to or from the wide mode of a wide TV
VOL +/� For DVPNS755V: WIDE MODE For DVPNS915V: WIDE MODE
Notes
� Depending on the connected unit, you may not be able to correctly control your TV or AV amplifier (receiver) using some of the buttons below. � If you enter a new code number, the code number previously entered will be erased. � When you replace the batteries of the remote, the code number you have set may be reset to the default setting. Set the appropriate code number again.
TV/VIDEO
Switches the TV�s input source between the TV and other input sources The button works even if the TV/DVD switch is set to DVD
For DVPNS755V: Number buttons and ENTER
Selects the channel of the TV
Controlling TVs with the remote
TV/DVD switch Number buttons -/--* [/1 VOL +/� TV/VIDEO WIDE MODE
For DVPSelects the channel of a Sony NS915V: TV Number buttons and -/--*
* When you use the number buttons to select the TV�s channel, press -/-- followed by the number buttons for two-digit numbers.
* DVP-NS915V only
1 2
Slide the TV/DVD switch to TV. Hold down [/1, and enter your TV�s manufacturer code (see �Code numbers of controllable TV�s� below) using the number buttons.
