PIONEER DVR-3100-S/WVXU
Instrukcja Obsługi

06

Recording

4 Press ì REC when you�re ready to start recording. � The recorder will only start recording from the DV IN/ OUT jack if there is a valid signal. Recording will also pause if the signal is interrupted during recording. Note � If your source is copy-protected using CopyGuard, you will not be able to record it. See Restrictions on video recording on page 46 for more details.

The recorder will automatically switch on and start recording when the other component comes on. Recording stops when the external component switches off. � To cancel Auto Start Recording, press STANDBY/ ON. The indicator goes off. � To cancel Auto Start Recording once recording has already started, press ì REC for 3 seconds, then STOP REC. Note � You can�t set Auto Start Recording when: � the recorder is recording or in timer recording standby. � there is no recordable disc loaded. � the disc loaded is locked. � the disc loaded already contains the maximum number of titles (99). � If Auto Start Recording is set, it will not start if another timer recording is in progress. � Timer recordings take precedence over Auto Start Recording. Auto Start Recording will stop if a timer recording is due to start. After the timer recording has finished, Auto Start Recording will resume.

Automatic recording from a satellite tuner
VR mode Video mode

If you have a satellite tuner or some other kind of set top box connected to the L3 input, you can have the recorder start and stop recording automatically with the timer settings of the connected component. (If the other component doesn�t have a built-in timer, you�ll need to use it with an external timer unit.) After setting up for Auto Start Recording, this recorder starts recording when it detects a signal from the other component. When the signal ceases, the recorder stops recording. Important � It takes a little while for this recorder to switch on and start recording after detecting a signal. Please bear this in mind when setting the timer. 1 Set the timer for the satellite receiver (or other component), then switch it into standby (if necessary). Check the manual that came with the receiver if you�re not sure how to do this. 2 Load a recordable disc into this recorder.

Recording from a DV camcorder
VR mode Video mode

You can record from a DV camcorder connected to the DV IN/OUT jack on the front panel of this recorder. Using the recorder�s remote, you can control both the camcorder and this recorder. Before recording, make sure that the audio input for the DV IN/OUT jack is setup (see DV Input on page 82).

3 Check that the �Audio In� settings for �External Audio� and �Bilingual Recording� are as you want them. See Audio In settings on page 81 for more on these settings. 4 Set up the recorder. � Use REC MODE to set the recording quality. See Setting the picture quality/recording time on page 46 for detailed information. 5 Press and hold the FUNCTION button on the front panel for 3 seconds. The recorder goes into standby and the AUTO indicator in the front panel display lights.

CLEAR

ENTER
HOME MENU RETURN

REV SCAN

PLAY

FWD SCAN

PAUSE

STOP

STEP/SLOW
REC MODE

ì

54
En