|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Preparing the remote controller
Insert the batteries into the remote controller so you can use it to operate the DVD player.
Operating with the remote controller
This section shows you how to use the remote controller.
1
Open the cover.
Point the remote controller at the remote sensor and press the buttons.
OPEN /CLOSE STOP PLAY
STANDBY/ON POWER
DIMMER
PAUSE
PHONES
PHONES LEVEL
ON STANDBY
OFF
MIN
MAX
DVD / VIDEO CD / CD PLAYER
DV-S 525
30°
30°
2
Insert batteries (AA size).
Within about 5 m (16-11/16 feet)
POWER
CLOSE OPEN/
FR
PLAY
FF
PAUSE/STEP
DOWN
STOP
UP
SLOW
MENU
SETUP
Distance: About 5 m(16-11/16 feet) from the front of the remote sensor Angle: About 30° in each direction of the front of the remote sensor Make sure to match the + and � on the batteries to the marks inside the battery compartment. * Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the DVD player with the remote controller.
3
Close the cover.
Notes on the remote controller:
� Direct the remote controller at the remote sensor of the DVD player. � Do not drop or give the remote controller a shock. � Do not leave the remote controller near an extremely hot or humid place. � Do not spill water or put anything wet on the remote controller. � Do not open the remote controller.
Notes on batteries:
Improper use of batteries may cause battery leakage and corrosion. To operate the remote controller correctly, follow the instructions below. � Do not insert the batteries into the remote controller in the wrong direction. � Do not charge, heat, open, or short-circuit the batteries. Do not throw the batteries into a fire. � Do not leave dead or exhausted batteries in the remote controller. � Do not use different types of batteries together, or mix old and new batteries. � If you do not use the remote controller for a long period of time, remove the batteries to avoid possible damage from battery corrosion. � If the remote controller does not function correctly or if the operating range becomes reduced, replace all batteries with new ones. � If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries. � The batteries should last about one year under normal usage.
11
Connections Introduction
|
|
|
> |
|
