|
Kto jest w sklepie?
Sklep przegląda 6043 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tip: The side that will be recorded when SIDE A of disc faces the hand strap is the opposite side to the "SIDE A" indication. Cautions: Most generally available 8 cm DVD- RAM discs can be removed from cartridges if they are for video cameras; However, before removing disc from cartridge, read the instruction sheet provided with the disc or consult the disc maker.
Laser
A
side A indication of disc
Surface to be recorded
Take care with the following when handling the removed disc: Be sure not to touch disc surfaces. Be careful not to drop the disc removed from cartridge. Be sure not to bend the disc. Do not leave the disc outside the cartridge. Do not subject the disc to heat. Do not write on disc with a ball- point pen or pencil. Be sure not to wipe disc surfaces with thinner,water or anti- static agent. Use dry, soft cloth to lightly wipe off dust or dirt that adheres to the disc. Never use solvents to clean the disc. If the disc is removed from cartridge and the data stored by this DVD video camera/recorder is rewritten on devices other than this DVD video camera/recorder,recording or playback may not be normal,or Disc Navigation may not operate normally,when the disc replaced in cartridge is used on this DVD video camera/recorder again. The cartridge protects the surfaces of disc on which high- density recording is possible.Once removed from cartridge, the disc can be replaced in the cartridge and used with this DVD video camera/recorder, but be sure to observe the following: Before replacing the disc in cartridge, make sure that disc surfaces are not scratched,and that no dirt or fingerprint adheres to them. Do not record,edit or delete on the disc when scratches, dirt or fingerprints cannot be removed even if disc surface is cleaned. When replacing the disc in cartridge, insert it until a click is heard. Writing similar to recording is be performed even with simple editing or deletion. Make sure that editing or deletion has been securely performed with the disc removed from cartridge.
Write-protect tabs
The DVD-RAM disc cartridge has write-protect tabs to prevent overwriting on recorded data. Make sure that the write-protect tab is set to the side where recording is possible. Cautions: Dust, scratches or dirt on the disc surface may cause block noise because of the principle of disc recording. This does not indicate a fault. Be careful when handling the disc so that no dirt or fingerprints adheres to the disc. This DVD video camera/recorder has a function that allows recording, avoiding portions of the disc with dust, scratches or dirt [The DVD video camera/recorder sets to pause ( ) status and automatically restarts recording ( REC )] . This will interrupt recording for several seconds to several minutes, and multiple thumbnails will be created in one recording as shown in the figure. In this case, the recordable time will decrease.
SideB Recording not possible Recording possible SideA
E1 - 5
|
|
|
> |
|