|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
E250P
Analog Receiver/Processor � Speaker-Level Connections
Use this installation method only with an analog receiver/ processor that does not have digital processing or bass management, and also does not have a subwoofer output or a volume-controlled preamp (line-) level output: Connect the speaker wires for both your main left and right speakers, and for the subwoofer, to the same speaker terminals on your receiver or amplifier. The wires may be joined by twisting together the bare ends of the two leads that will be connected to each terminal on the receiver/ amplifier, as shown in the diagram. This procedure should be done only four times (involving a total of eight barewire ends), and only for those wire ends that are being connected to the terminals on your receiver/amplifier. It is important that you avoid joining any other wires. Do not twist together wire ends that are being inserted into terminals on any speaker or on the subwoofer. Do not twist together wire ends that will be used for any speakers other than the front left and right speakers or the subwoofer. Refer to the connection diagram for guidance. Twist together the (+) leads at one end of the speaker wires that you have designated for the left front speaker and for
To (+) terminal on left speaker To (+) terminal of left input on subwoofer Left Front
the left high-level inputs on the subwoofer. Insert the joined (twisted) wires into the left front (+) terminal on your receiver/amplifier. Connect the free end of the (+) lead for the left front speaker to the (+) terminal on the back of the speaker. Connect the free end of the (+) lead for the left input on the subwoofer to the left binding-post terminal. Repeat this process for the (�) connections for the left front
Left Front
speaker and left input on the subwoofer, and then for the (+) and (�) connections for the right front speaker and right high-level inputs on the subwoofer. Connect your receiver or amplifier�s center and surround speaker terminals to the corresponding terminals on the back of your center and surround speakers.
+
�
+
Center
Right Front
�
+
�
Subwoofer
L
HIGH LEVEL IN
+
�
Receiver
Center
R
Right Front
+
�
+
�
+
Twist Here
�
Left Surround
Twist Here
Right Surround
+
�
+
�
Left Surround
Right Surround
+
�
+
�
To front left (+) terminal on receiver/amplifier
5
|
|
|
> |
|
