Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Operating sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer.
Release the ON/OFF button (the mains-ON light goes out) and immediately remove the laundry.
After each use
� Turn the programme selector dial to �0�. � Switch the appliance off by releasing the ON/OFF button . The mains-ON light goes out. � Clean the filters (see page 14). Important! If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to �0�. Select the new programme and press the Start button .
Drying
1. Connect the appliance. 2. Open the door.
P1104
P1108
3. Load the items one at a time, shaking them out loosely. 4. Close the door. Please check the laundry does not get caught between the door and filter. 5. Press the ON/OFF button comes on. : the mains-ON light
6. Select the drying programme or time. 7. If required, press the low temperature button and/or the buzzer OFF button . 8. Press the Start button for 2 seconds: light comes on and drying starts. The drum turns alternately in both directions during drying. All drying programmes end with a 10 minute cooling phase (light is on). You may remove the laundry after this phase. 9. If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 minutes maximum). The buzzer sounds every 10 seconds (if the button has not been pressed). Lights and flash alternately. If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. Light flashes and the mains-ON light stays on. Turn the programme selector dial to �0�; light goes out. 12
