Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
Special accessories
Active carbon filter
When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 180
Installation
Unpacking
Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it.
Min 60 cm
Min 70 cm
Placement
The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 60 cm. above electric burners or 70 cm. above gas or mixed-fuel burners. (Fig. 4). Fig. 4
H I H I
OPEN
Electrical connection
The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power cord length is 1 m.
H
Mounting of hood on wall
l Fix the drilling template to the wall (Fig. 5). l Make 3 � 8 mm holes in the wall. 2 at points H, 1 as desired at points I. l Insert the three � 8 mm expansion plugs into the wall. l Insert 2 5x45 screws at points H but do not tighten them completely. l Open the grid. l Fit the hood into holes H, tighten the 2 screws.
CLOSED
I
H I
I
H
Fig. 5
H I
l From inside the hood, insert the third 5x45 screw into hole I (Fig. 6). 5
