WHIRLPOOL EH18EFXPW2
Instrukcja Obsługi

Using .your freezer
Setting the temperature control...
Control to

Adjusting

the temperature

control...
temper-

I. Insert a coin in the slot of the Temperature turn it.

1 Turn control to higher number atures. 2. Turn to lower number

for colder

2. Turn control to Number 3. This setting is designed to maintain the temperature at or near 0°F ( ~ 17.8�C) under normal operating conditions.

for less cold temperatures.

Cooling freezer first...
1 Allow freezer to cool 6 to 8 hours before filling with

frozen food.
2. Let it cool overnight before adding large amount of unfrozen food. Note: When freezer is first started, the compressor will run constantly until the cabrnet is cooled It may take up to 6 to 8 hours or longer, depending on room temperature and the number of times the freezer door is opened. After the cabinet is cooled, the compressor WIII turn ON and OFF as needed to keep the freezer at the proper temperature

The sliding baskets...
Can be moved from side to side or removed loading or unloading food below it. when

To remove:
Lift basket out

To replace:
l.ower basket into place

The key eject lock...
can help entrapment reduce the hazard of child To lock or unlock the freezer you must hold the key rn the lock while turning The lock IS sprrng loaded so the key cannot be left in the lock. If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always grve the complete model and serial number of your freezer when requesting a replacement key.

The signal light...
automatically failure.
l l l

warns

of any unexpected

power check:

To replace:
1. Unplug power cord from outlet. 2. Carefully snap out light cover and assembly with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer. 3. Unplug burned out signal light and replace with a new one. Signal light can be ordered from your WHIRLPOOL dealer 4. Then, snap light assembly into place. 5. Plug power cord into outlet.

If the signal light is not glowing, immediately for power interruption, for an unplugged power cord, for a burned out signal light.