WHIRLPOOL EHT182VKWR2
Instrukcja Obsługi

Adjusting
Arrange

the Shelves

and Meat Pan.

11lt the Front, Lift the Back

your refrigerator shelves and meat pan to suit yourself. You can put two shelves together to make one full-width shelf, or put them on different levels. To remove them, tilt up at the front. Then lift up at the back. When replacing them, keep them tilted; guide the rear hooks into the Slots in the shelf bracket. Lowerthe front. Before moving the meat pan itself, remove the pan by pulling it out, lifting the front and then pulling out the rest of the way.

Removing

Non-Adjustable

Shelves.

To remove a shelf, lift up the front. Then lifl up at the back. To replace it, put the rear notches onto the shelf supports. Lower the front into place.

Optional

ICE MAGIC�

Automatic

Ice Maker.

Then the Back

On

If you have the automatic Ice maker accessory o( plan to add one later [Part No. ECKMF-6). there are a few things you will want to know l The ON; OFF lever is a wire slgnal arm. Down...for making ice automatically, Up to shut off the Ice maker. l Shake the bin occasionally to keep cubes separated, and to obtain Increased storage capacity . It IS normal for Ice crescents to be attached by a corner. They WIII break apart easily You WII! hear water running when tee maker IS working. You�ll hear Ice fall Into the bin Don�t let these sounds bother you l The ice maker WIII not operate until the freezer is cold enough to make ice This can take overnight l Because of new plumbing connectlons, the first ice may be dlscolored or off-flavored, Discard the ftrst few batches of ice. . If ice is not being made fast enough and more Ice IS needed, turn the Refrtgerator Control toward a higher number. Walt a day and, if necessary, turn the Freezer Control toward A. l If you remove the Ice bin, raise the slgnal arm to shut off the ice maker. When you return the bin, push it all the way In and lower the arm to the ON posltlon . If cubes are stored too long, they may develop an off-flavor. .like stale water. Throw them away They will be replaced. Cubes In the Ice bin can also become smaller by evaporation.
l

Raise Slgnal Arm to Stop Ice Maker. Lower Signal Arm to Start It.

Replacing

the Light Bulb.

When the light bulb needs replacing, you wtll find you can reach It easily without removing anythlng To remove the light bulb first unplug the refrigerator Then, reach behlnd the control console You can feel the bulb Remove It Replace the bulb with a 40.watt appllante Dulb available from most grocery, hardware or variety stores

Removing

the Crispers

and Crisper

Covers.

To remove the crispers, slide them out until they stop Lift the front a little and slide them the rest of the way out Each cover IS held IV place by two pegs at the back and two notched tabs in the front Press the tabs out of the way to lift the front Lift the back off the pegs To put the covers back replace the center leg Replace each cover by first flttlng the back notches over the pegs Then push the front down Into the notched tabs The center leg can be made shorter or longer to help level the crisper covers, if necessar\/ Turn the leg clockwtse to make the leg longer Turn It counterclcckwlse to shorten the leg
Push the lab to Clear the Cover

5