WHIRLPOOL EJT142XKWR0
Instrukcja Obsługi

Adjusting

the Shelves.

Pull Shelf Out Until It Stops. Lift the Front and Pull Again

Adjust your refrigerator shelves to match your food storage needs for tall items, short items or sizes in between. It will be easier to move a shelf if you take off all the food first. Slide the shelf you want to move toward you until it stops. Lift up the front and slide it out the rest of the way. To put it back on the shelf guides, fit the back of the shelf on top of the guides with the wire stops on the bottom of the guides. Slide it in, keeping the front lifted up until the stops on the shelves clear the stops on the guides.

Optional

ICE MAGIC�

Automatic

Ice Maker.

Raise Signal Arm to Stop Ice Maker. Lower Slgnal Arm to Start It. Lift the Front, Then the Back.7

If you have the automatic ice maker accessory or plan to add one later [Part No. ECKMF-28), there are a few things you will want to know: On the side of your ice maker is a wire signal arm. When it�s down, the ice maker will make ice automatically. Raise the arm to shut off the ice maker. Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. It is normal for the cubes to be attached by a corner. They will break apart easily. You will hear water running when the ice maker is workrng. You�ll hear ice fall into the bin. Don�t let these new sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Your ice maker will work faster when the freezer is colder. If you want more ice, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A. If you remove the ice bin, make sure you raise the signal arm to shut off operation. When you put the bin back, make sure it�s all the way in and the arm is lowered. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

Removing
Lift the Front and Pull Again

the Crispers

and Crisper

Cover.

To remove the crispers, slide them out until they stop. Lift the front a little and slide them the rest of the way out. The cover rests on nubs built into the side walls of the refrigerator. To remove the cover, lift the front and then the back. To replace the cover, fit the notches in the back corners of the cover over the nubs at the back of the walls. Then lower the front into place. To replace the crispers, slide them in, keeping the front lifted a little until the crispers clear the stops.

Replacing

the light

Bulb.

When the light bulb needs replacing, you will find you can reach it easily without removing anything. To remove the light bulb, first unplug the refrigerator. Then, reach behind the control console. You can feel the bulb. Remove it. Replace the bulb with a 40-watt appliance bulb available from most grocery, hardware or variety stores.

5