WHIRLPOOL EJT181XKWR0
Instrukcja Obsługi

Adjusting

the Shelves

and Meat Pan.

Tilt the Front; Lift the Back

Arrange your refrigerator shelves and meat pan to suit yourself. You can put two shelves together to make one full-width shelf, or put them on different levels. To remove them, tilt up at the front. Then lift up at the back. When replacing them, keep them tilted; guide the rear hooks into the slots in the shelf bracket. Lower the front. Before moving the meat pan itself, remove the pan by pulling it out, lifting the front and then pulling out the rest of the way.

Removing

Non-Adjustable

Shelves.

To remove a shelf, lift up the front. Then lift up at the back. To replace it, put the rear notches onto the shelf supports. Lower the front into place.

Optional
Lift the Front; Then the Back

ICE MAGIC&

Automatic

Ice Maker.
or plan to add you will want to

If you have the automatic ice maker accessory one later (Part No. ECKMF-6), there are a few things

Raise Signal Arm to Stop Ice Maker Lower Signal Arm to Start It.

know: On the side of your ice maker is a wire signal arm. When its down, the ice maker will make ice automatically. Raise the arm to shut off the ice maker. Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. It is normal for the cubes to be attached by a corner. They will break apart easily. You will hear water running when the ice maker is working. You�ll hear ice fall into the bin. Don�t let these new sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Your ice maker will work faster when the freezer is colder. If you want more ice, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A. If you remove the ice bin, make sure you raise the signal arm to shut off operation. When you put the bin back, make sure its all the way in and the arm is lowered. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

Replacing

the light

Bulb.

When the light bulb needs replacing, you will find you can reach it easily without removing anything. To remove the light bulb, first unplug the refrigerator. Then, reach behrnd the control console. You can feel the bulb. Remove it. Replace the bulb with a 40-watt appliance bulb available from most grocery, hardware or variety stores

Removing

the Crispers

and Crisper

Covers.

Push the lab to Clear the Cover

To remove the crispers, slide them out until they stop. Lift the front a little and slide them the rest of the way out. Each cover is held in place by two pegs at the back and two notched tabs in the front. Press the tabs out of the way to lift the front. Lift the back off the pegs. To put the covers back, replace the center leg. Replace each cover by first fitting the back notches over the pegs. Then push the front down into the notched tabs. The center leg can be made shorter or longer to help level the crisper covers, if necessary. Hold the leg and turn the top part counter-clockwise to make the leg longer. Turn it clockwise to shorten the leg.

5